Fehler #272
PIN Standby verification
Beginn:
05.10.2022
Abgabedatum:
% erledigt:
0%
Geschätzter Aufwand:
CS Zielversion:
Beschreibung
E.g. the NJRST is internally connected to an pullup when in standby.
When an LED is connected it can be seen.
If such an pin is e.g. connected to an wakup-button, it would also draw current in standby.
So in standby all voltages have to be measured to find pins that must not be used in wrong modes.
- Does it draw current when pushed high externaly? Resistance to GND.
- Does it draw current when pulled low externaly? Resistance to VDD.
Bootloader conditions are not that important. It will likely do something on the pins.
Historie
Von
Von Maximilian Seesslen vor mehr als 2 Jahren aktualisiert
Just disable debug in standby mode.
According to reference manual
all GPIOs are high impedance in standby mode except configured wakeup pins and alarms.
Von Maximilian Seesslen vor mehr als 2 Jahren aktualisiert
- Status wurde von Neu zu Abgewiesen geändert
Just disable debug in standby mode.