Aktivität

von 10.01.2024 bis 08.02.2024

22:56 Feature #347 (Erledigt): Send battery level via CAN: Maximilian Seesslen
22:54 Feature #479 (Erledigt): Check behaviour when device is immediately shut off before button release: Maximilian Seesslen
22:51 Requirement #478 (Erledigt): LED States: Maximilian Seesslen
22:51 Requirement #481 (Erledigt): Send Event-error when battery is too low: Maximilian Seesslen
22:11 Requirement #480 (Erledigt): Configurable auto-off timeout: Maximilian Seesslen
22:02 Requirement #482 (Erledigt): Pseudo-Off: Maximilian Seesslen
22:02 Requirement #483 (Erledigt): Wait for button-release on shutdown: Maximilian Seesslen
21:51 Requirement #483 (Erledigt): Wait for button-release on shutdown: When shutdown via button is triggered, a state has to wait untill the button is released.
Otherwise the device would... Maximilian Seesslen

18:37 Requirement #482 (Erledigt): Pseudo-Off: Due to non-functional WKUP, the first boards should not got to standby because
they can not be woken up any more.
... Maximilian Seesslen
18:01 Requirement #481 (Erledigt): Send Event-error when battery is too low: Target voltage is 2,4V.
Check should be done every 15min.
Error should be send at 2,2V (end-point voltage of NiMH i... Maximilian Seesslen
17:48 Requirement #480 (Erledigt): Configurable auto-off timeout: After an configurable ammount of time, the device should automatically turn off.
The 'off' is an hard power-off. O... Maximilian Seesslen
17:29 Feature #479 (Erledigt): Check behaviour when device is immediately shut off before button release: I assumed that the device will immediately repower on when shutting down while button is still pressed.
Has to be ve... Maximilian Seesslen
17:27 Requirement #478 (Erledigt): LED States: * The LED is permanent on in operational mode
* The LED is blinking normal when shutdown was initiated by holding bu... Maximilian Seesslen

Auch abrufbar als: Atom

Software » Mainswitch