Description » Historie » Version 9
Maximilian Seesslen, 02.02.2024 13:44
| 1 | 1 | Maximilian Seesslen | h1. Description |
|---|---|---|---|
| 2 | |||
| 3 | 8 | Maximilian Seesslen | "MainSwitch" is an 5V power supply which can be isolatied from power grid by SSR. |
| 4 | 7 | Maximilian Seesslen | |
| 5 | 5 | Maximilian Seesslen | The "mainSwitch" is the main total off button. |
| 6 | The PCB supplies the CANbus with integrated power supply (from 240V). |
||
| 7 | 2 | Maximilian Seesslen | When device is in off-state, it is isolated from 240V via SSR. |
| 8 | 1 | Maximilian Seesslen | To switch it to "on", it has an big button. The device contains an battery. |
| 9 | 2 | Maximilian Seesslen | |
| 10 | 5 | Maximilian Seesslen | It has terminal for USB slots to load mobile devices. It can power up to 5W(1A@5V). |
| 11 | 2 | Maximilian Seesslen | |
| 12 | Pressing the button again will bring device in "off" state. |
||
| 13 | The battery voltage is monitored. Low voltage gets detected and indicated by |
||
| 14 | 6 | Maximilian Seesslen | the LED or Buzzer. |
| 15 | 3 | Maximilian Seesslen | |
| 16 | The device has an CAN interface. It can be switched to off-mode by CAN message. |
||
| 17 | 4 | Maximilian Seesslen | |
| 18 | 6 | Maximilian Seesslen | The PCB is designed to be mounted into an box. There are no controls directly |
| 19 | 4 | Maximilian Seesslen | on the board. |
| 20 | 7 | Maximilian Seesslen | |
| 21 | "mainSwitch" can measure the consumed current on the 5V side. |
||
| 22 | This information is send via CAN. |
||
| 23 | 9 | Maximilian Seesslen | |
| 24 | It has no forther IOs than the button, also no PWM output. CANSwitch is responsible for that. |