Hardware

h1. Roadmap

h2. Ongoing

* MainSwitch
* Miniminutnik eInk
* Kastella (i need plants)



h2. To be started

* -CANIO L- CANIO L
* -Lighttimer/Switchbox- Lighttimer/Switchbox
** -CANIO-L- CANIO-L
* Lichtwecker
** -CANIO-L- CANSwitch
* Canbridge
* Meteor; The BME680 has an accurracy of 0.5°C typical. So an additional more precice temperature sensor would be nice
** ordered TMP117, +-0.1°C at –20°C to 50°C; total operation range: –55°C to 150°C
* CANSpeaker; I have these bigger smd speakers. CANDisplay is not very loud.
* -Sensemux- Sensemux
** -verificate verificate some stuff. CANSpeaker, Sensors, alarm-clock, plant-lamp- plant-lamp
* eInk Minutnik
** WSH-12561; 37,32x31,8;
** AKKU 31063 (Garmin Fenix 3) 300mAh; 300 mAh; 31,6 x 24,8 x 4,3
** Pixel-data is 5KB ((200*200)/8); need bigger MCU; but the STM32L433CCU6 i have is too much
** STM32L151C6U6A waers eigentlich. USB, -128KB Flash, 32KB SRAM, EEPROM- 32KB Flash, 10KB RAM, hat USB
** STM32L051C8T6; no USB
* -CANControl, CANControl, Is this really needed- needed
** -Controller Controller with RTC, automatic on/off of CANSwitches- CANSwitches
** -Controlls Kastella- Controlls Kastella
* Bathroom clock



h2. (nearly) Finished

* Amp
* Miniminutnik
** -Further Miniminutniks; v0.2.x; UART works at least in debug mode.-
* CANIO (S)
* Temprec
* Slonce I
* Candisplay (i finally need light switches)
* -Isoler; small dc/dc adapter, 2 LEDs-
** Test it on breadboard first
** When it works: small cable adapter.
** https://www.reichelt.de/dc-dc-wandler-am1p-z-1-w-5-v-200-ma-dil-8-sim1-0505s-dil8-p35039.html?search=sim1-0505
** https://www.reichelt.de/dc-dc-wandler-tea-1-1-w-4-5-5-5-5-0-vdc-sil-4-tea-1-0505-p288651.html