Hardware » Bringup

h1. Eval

* Big LEDs to test outputs / Backlight-PWM
* Amplified Buzzer to test buzzer output directly on MCU
* PWM output to test buzzers; 3V; normal and amplified
* Test for CANBus-cables;
** MCU with 4 inputs
** 4 outputs to control which line to be tested to detect shortcuts
** 4 outputs for LEDs to indicate errornous wire
** How detect shortcuts
** Button to reset
* Durchgangsprüfer ( buzzer-out / Buzzer-in )
** Do i really need this? Dont want to setup an multimeter
** Does not cost much
** The signal is already there. It might be usefull to inspect the board

h2. Functions

* Measure power consumption of boards
* Measure functions of PCBs (PWM Buzzer, Backlight)
* Measure periphery (e.g. buzzers)
* Test CANBus wires

h2. Buchsen

* GND
* Durchgang
* PWM out
* PWM in to buzzer
* LED/BL in to big LED
* Strom-Mess-Durchgang mit Schiebeschater; e.g. 1101M2S3CGE2

* 2xJST-4; Kabeltest
** Auch ueber Stiftbuchse fuer Schoenes Gehaeuse, Acryl ala Ophio

Stiftleiste

* GND
* 3V
* 5V
* LED in 1
* LED in 2
* LED in 3
* LED in 4

* 2 Buzzers
* 1 Big LED
* Heardbeat
* User
* 1 Buzzer reset test
* 4 LEDs "open connection"

h2. MCU Pins

* 4 GPIO out cable-test
* 4 GPIO Input test
* 4 GPIO LEDs
* 1 LED "Running" amber
* 1 LED "Good" green
* 1 LED "Failed" red
* 1 LED "Not 1:1" orange
* PWM buzzer
* Button start testing
* 2 LEDs HB, User

20 Pins; STM32G030C8T6 Cheap and boring LQFP48;

2 Uart
2 I2C
2 Pow

h2. No-MCU version

* 4-Pin JST Power fuer CCandis Versorgung
* 2-Pin JST CAN outlet for PC adapter
* 2-Pin JST Power fuer Miniminutnik
* 3-Pinheader Power VOUT, 5V, 3V, GND
* Spannungsregler 5V; L78M05; was habe ich von den LED-Reglern?
* Spannungsregler 3V
* 2 Pin VIN; 8-24V 24V
* 2 Pin Measure
* Schieberegler Shortcut; 1101M2S3CGE2
* Strom messung 5V/3V; Schieber; 1201M2S3CQE2
* 3 * Power-LED
* 4 * LED-In; 3V
* Buzzer-Input

Je nach Stellung des Spannungs-Schiebeschalter sind an den Spannungsausgaengen nur 5V oder nur 3V verfuegbar.
Testbar:

** Buzzer-PWM-Ausgang
** 4*3V Ausgaenge
** Backlight-PWM (Weisse LED ueber Mosfet)
** CAN durchgeroutet an PEAK Adapter

Nicht testbar:

** Buzzer an sich; "bringup" ist kein Funktionsgenerator
** I2C Ausgang; There are enough sensors around