Feature #454
Von Maximilian Seesslen vor etwa 1 Jahr aktualisiert
Smoothing and error detection was implemented.
Once the LED-Lamp was switched off, the noise was completely gone.
Verify if there are still errors and smoothening could be switched off in normal environment.
--
There is still some noise but no errrors any more.
Filtering the errors is fine. But there is still an shift in the values when LED lamp is on.
There are also errors when CANBridge is active. values.
* Put But rufa in a metal box
* Run rufa with an powerbank
* Rufa can go to error-Blinking again when dropped messages; big noise is a problem, not a feature
* Send Warning-Status to cordyceps: send device-status; remove object if problem is gone
** Good
** Warning
** Poor environment
** Dead, non-functional
* Shift also existant just with CANBridge?
Once the LED-Lamp was switched off, the noise was completely gone.
Verify if there are still errors and smoothening could be switched off in normal environment.
--
There is still some noise but no errrors any more.
Filtering the errors is fine. But there is still an shift in the values when LED lamp is on.
There are also errors when CANBridge is active. values.
* Put But rufa in a metal box
* Run rufa with an powerbank
* Rufa can go to error-Blinking again when dropped messages; big noise is a problem, not a feature
* Send Warning-Status to cordyceps: send device-status; remove object if problem is gone
** Good
** Warning
** Poor environment
** Dead, non-functional
* Shift also existant just with CANBridge?