Feature #443
Von Maximilian Seesslen vor etwa 1 Jahr aktualisiert
When the button is pressed, the mode shall change.
validate:
* check the cable layout only on start
* check permanent for the lowest ADC values
* check permanent for shortcuts
live:
* just show the current values
The button needs to be soldered. What did damage it? soldering? supersonic?
conditions are:
* perfect: super high voltages on ADCs
* good: OK-ish voltages like 5m cable
* ok: OK-ish voltages like 10m cable
* bad: too low voltages
* broken: shortcut or loose connection
validate:
* check the cable layout only on start
* check permanent for the lowest ADC values
* check permanent for shortcuts
live:
* just show the current values
The button needs to be soldered. What did damage it? soldering? supersonic?
conditions are:
* perfect: super high voltages on ADCs
* good: OK-ish voltages like 5m cable
* ok: OK-ish voltages like 10m cable
* bad: too low voltages
* broken: shortcut or loose connection